Heat spreading
Thin graphite parts move heat laterally away from concentrated sources.
Solution
Thermal Management Components for Robotics & Drones
Custom graphite heat spreaders, thermal interface pads and insulating constructions designed around heat source, interface gap, mounting pressure and available space.
Grade-specific performance is supplied with the recommended material. Final assembly validation remains application-specific.
Why the material alone is not the answer
Compact flight controllers, ESCs, motor drivers and robot controllers concentrate heat inside lightweight enclosures. A material selected by conductivity alone can underperform when gap, contact pressure, flatness and electrical isolation are ignored.
Common install positions
- Flight controller and processor
- ESC and motor driver
- AMR / AGV controller
- Battery and power module
- Camera or sensor electronics
Match each function to the assembly.
Gap filling
Compliant silicone pads bridge interface variation between a component and heat sink or housing.
Isolation
PET or PI layers can be integrated when electrical separation is required.
Laminated construction
Adhesive, liner and protective films can be converted into an assembly-ready part.
Selection data
What we need to review your design
Send the information available now. Missing values can be identified during drawing review rather than guessed.
- Heat source and target surface
- Gap and flatness
- Operating and peak temperature
- Mounting pressure
- Electrical isolation need
- Drawing and annual volume
Configurable parts for this function
Thermal Graphite Sheets
Review product options
Thermal Silicone Pads
Review product options
PET & PI Insulation Parts
Review product optionsBefore you specify the part
Graphite sheet or thermal pad?
Graphite is normally selected for lateral heat spreading, while a thermal pad bridges an interface gap. Some assemblies use both in a laminated stack.
Can you die-cut around components and connectors?
Yes. Geometry is reviewed against material thickness, brittleness, minimum web and lamination construction before tooling.
Engineering review
Review a thermal management challenge with our engineers
Tell us the installation position, material challenge, environment and project stage. Our team will review the drawing and recommend a practical construction.