Application
EMI Shielding Components for UAV Electronics
Create controlled conductive contact and seam coverage around flight electronics, radios, cameras and power modules using custom tape and compressible gasket constructions.
The recommended stack is defined from the actual housing, interface and validation target.
Design constraints
What the assembly must balance
- Motors and power switching
- Radio coexistence
- Limited grounding area
- Low gasket height
- Weight-sensitive enclosure
Position-to-part map
Build the stack by function
01PCB ground point
Die-cut conductive fabric tape
02Housing seam
Conductive foam gasket
03Cable or connector area
Shaped tape or local shielding patch
04Sensitive module
Application-specific shielding and insulation stack
Drawing review
Inputs that move the project forward
Provide what is known; our review will make the open decisions visible.
- Noise source
- Affected frequency
- Ground path
- Joint geometry
- Compression range
- Surface and adhesive
Relevant components
Candidate product families for this assembly
Conductive Foam Gaskets
Review product optionsApplication validation required
Fit, thermal, shielding, vibration, dielectric and ingress performance must be verified in the customer’s complete assembly under intended use conditions.
Engineering review
Discuss your drone emi shielding assembly
Tell us the installation position, material challenge, environment and project stage. Our team will review the drawing and recommend a practical construction.