Application
Drone Camera & Gimbal Vibration Isolation
Protect camera and gimbal modules with custom foam pads and cushioning parts designed around compression, rebound, alignment and available assembly space.
The recommended stack is defined from the actual housing, interface and validation target.
Design constraints
What the assembly must balance
- Image stability
- Precision alignment
- Low mass
- Repeated vibration
- Restricted optical clearances
Position-to-part map
Build the stack by function
01Camera module support
Low-profile cushioning pad
02Gimbal interface
Foam or silicone element selected for compression
03Lens / sensor perimeter
Dust-control foam or gasket
04Electronics
Thermal and insulation parts where needed
Drawing review
Inputs that move the project forward
Provide what is known; our review will make the open decisions visible.
- Supported mass
- Installed gap
- Target compression
- Vibration profile
- Temperature
- Alignment features
Relevant components
Candidate product families for this assembly
EVA & Silicone Foam Cushion Pads
Review product options
Thermal Silicone Pads
Review product options
Dust Mesh & Vent Membranes
Review product optionsApplication validation required
Fit, thermal, shielding, vibration, dielectric and ingress performance must be verified in the customer’s complete assembly under intended use conditions.
Engineering review
Discuss your drone camera & gimbal assembly
Tell us the installation position, material challenge, environment and project stage. Our team will review the drawing and recommend a practical construction.