Application
LiDAR & Sensor Sealing and Protection
Combine sealing, cushioning, venting and EMI control around LiDAR and sensor modules without treating every protection requirement as a single-material problem.
The recommended stack is defined from the actual housing, interface and validation target.
Design constraints
What the assembly must balance
- Optical alignment
- Outdoor contamination
- Pressure equalization
- Heat and EMI
- Complex housing geometry
Position-to-part map
Build the stack by function
01Window perimeter
Die-cut foam sealing gasket
02Vent opening
Mesh or hydrophobic membrane construction
03PCB / processor
Thermal interface and insulation
04Housing seam
Conductive gasket where grounding is required
Drawing review
Inputs that move the project forward
Provide what is known; our review will make the open decisions visible.
- Sensor and housing drawing
- Opening geometry
- Compression
- Airflow or acoustic need
- Temperature
- Ingress validation target
Relevant components
Candidate product families for this assembly
Dust Mesh & Vent Membranes
Review product options
Thermal Silicone Pads
Review product options
Conductive Foam Gaskets
Review product optionsApplication validation required
Fit, thermal, shielding, vibration, dielectric and ingress performance must be verified in the customer’s complete assembly under intended use conditions.
Engineering review
Discuss your lidar & sensor protection assembly
Tell us the installation position, material challenge, environment and project stage. Our team will review the drawing and recommend a practical construction.