Application
AMR & AGV Controller Thermal Management
Custom thermal-interface, shielding and insulation components for compact mobile-robot controllers, power electronics and communication modules.
The recommended stack is defined from the actual housing, interface and validation target.
Design constraints
What the assembly must balance
- Continuous duty
- Enclosed controller
- Power and RF coexistence
- Vibration
- Serviceability
Position-to-part map
Build the stack by function
01Processor and power stage
Thermal pad or graphite spreader
02Enclosure seam
Conductive foam gasket
03PCB / chassis interface
Die-cut electrical insulation
04Connector and module support
Cushioning or anti-rattle foam
Drawing review
Inputs that move the project forward
Provide what is known; our review will make the open decisions visible.
- Controller layout
- Heat sources
- Gap and compression
- EMI concern
- Voltage requirement
- Environmental condition
Relevant components
Candidate product families for this assembly
Thermal Graphite Sheets
Review product options
Conductive Foam Gaskets
Review product options
PET & PI Insulation Parts
Review product optionsApplication validation required
Fit, thermal, shielding, vibration, dielectric and ingress performance must be verified in the customer’s complete assembly under intended use conditions.
Engineering review
Discuss your amr / agv controller assembly
Tell us the installation position, material challenge, environment and project stage. Our team will review the drawing and recommend a practical construction.